Dell PowerEdge M805 - Manual (Page 595)

IGMP Commands 599
User Guidelines
This command has no user guidelines.
Example
The following example configures a robustness value of 10 for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ip igmp robustness 10
ip igmp startup-query-count
Use the ip igmp startup-query-count command in Interface Configuration mode to set the
number of queries sent out on startup - at intervals equal to the startup query interval for the
interface.
Syntax
ip igmp startup-query-count count
no ip igmp startup-query-count
• count—The number of startup queries. (Range: 1-20)
Default Configuration
2 is the default count value.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets for VLAN 15 the number of queries sent out on startup at 10 .
console(config)#interface vlan 15
console(config-if-vlan15)#ip igmp startup-query-count 10
ip igmp startup-query-interval
Use the ip igmp startup-query-interval command in Interface Configuration mode to set the
interval between general queries sent at startup on the interface.