Ospf commands, Area default-cost, 50 ospf commands – Dell PowerEdge M805 User Manual
Page 669
OSPF Commands
675
OSPF Commands
area default-cost
Use the area default-cost command in Router OSPF Configuration mode to configure the
monetary default cost for the stub area. Use the no form of the command to return the cost to the
default value.
Syntax
area area-id default-cost integer
no area area-id default-cost
•
area-id—Identifies the OSPF stub area to configure. (Range: IP address or decimal from
0-4294967295)
•
integer—The default cost for the stub area. (Range: 1-16777215)
Default Configuration
10 is the default configuration for integer.
Command Mode
Router OSPF Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example identifies a stub area of 10 and default cost of 100.
console(config)#router ospf
console(config-router)#area 10 default-cost 100