Dell PowerEdge M805 - Manual (Page 685)

OSPF Commands 691
no external-lsdb-limit
• integer—Maximum number of non-default ASexternal-LSAs allowed in the router's link-
state database. (Range: -1 to 2147483647)
Default Configuration
-1 is the default configuration.
Command Mode
Router OSPF Configuration mode
User Guidelines
The external LSDB limit MUST be set identically in all routers attached to the OSPF
backbone and/or any regular OSPF area.
Example
The following example configures the external LSDB limit for OSPF with the number of non-
default ASexternal-LSAs set at 20.
console(config-router)#external-lsdb-limit 20
ip ospf
Use the ip ospf command in Interface Configuration mode to enable OSPF on a router interface.
Use the no form of the command to disable OSPF on the interface.
Syntax
ip ospf
no ip ospf
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example enables OSPF on VLAN interface 15.
console(config-if-vlan15)#ip ospf