Dell PowerEdge M805 - Manual (Page 714)

720 OSPFv3 Commands
www
.dell.com | support.dell.com
Syntax
area areaid nssa
no area areaid nssa
• areaid—Valid OSPFv3 area identifier.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures area 1 to function as an NSSA.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 nssa
area nssa default-info-originate
Use the area nssa default-info-originate command in Router OSPFv3 Configuration mode to
configure the metric value and type for the default route advertised into the NSSA. The optional
metric parameter specifies the metric of the default route. The metric type can be comparable
(nssa-external 1) or noncomparable (nssa-external 2). Use the no form of the command to return
the metric value and type to the default value
Syntax
area areaid nssa default-info-originate [metric [comparable | non-comparable]]
no area areaid nssa default-info-originate
• areaid—Valid OSPFv3 area identifier.
• metric—Metric value for default route. (Range: 1-16777215)
• comparable—Metric Type (nssa-external 1). (Range: 1-16777214)
• non-comparable—Metric Type (nssa-external 2). (Range: 1-16777214)
Default Configuration
If no metric is defined, 10 is the default configuration.