Dell PowerEdge M805 - Manual (Page 53)

Command Groups 15
no cut-through mode Disables the cut-through mode on the switch. GC
no standby Unconfigures the standby in the stack. Stack GC
ping Sends ICMP echo request packets to another node on the
network. UE
reload Reloads the operating system. PE
set description Associates a text description with a switch in the stack. GC
show boot-version Displays the boot image version details. PE
show cut-through mode Show the cut-through mode on the switch. PE
show ip interface out-of-band Disables DHCP/BOOTP on the OOB port. PE
show memory cpu Checks the total and available RAM space on the switch. PE
show process cpu Checks the CPU utilization for each process currently
running on the switch. PE
show sessions Displays a list of the open telnet sessions to remote hosts. PE
show stack-port Displays summary stack-port information for all interfaces. PE
show stack-port counters Displays summary data counter information for all
interfaces. PE
show stack-port diag Displays front panel stacking diagnostics for each port. PE
show stack-standby Shows the Standby configured in the stack. PE
show supported switchtype Displays information about all supported switch types. UE
show switch Displays information about the switch status. UE
show system Displays system information. UE
show system id Displays the service ID information. UE
show users Displays information about the active users. PE
show version Displays the system version information. UE
stack Sets the mode to Stack Global Config. GC
standby Configures the standby in the stack. Stack GC
switch priority Configures the ability of the switch to become the
Management Switch. GC
switch renumber Changes the identifier for a switch in the stack. GC
telnet Logs into a host that supports Telnet. PE
traceroute Discovers the IP routes that packets actually take when
travelling to their destinations. PE
*NOTE: For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command Description Mode*