Layer 3 commands, Arp commands, Dhcp and bootp relay commands – Dell PowerEdge M805 User Manual
Page 70
32
Command Groups
www
.dell.com | support.dell.com
Layer 3 Commands
ARP Commands
DHCP and BOOTP Relay Commands
Command
Description
Mode*
arp
Creates an Address Resolution Protocol (ARP) entry.
GC
arp cachesize
Configures the maximum number of entries in the ARP
cache.
GC
arp dynamicrenew
Enables the ARP component to automatically renew
dynamic ARP entries when they age out.
GC
arp purge
Causes the specified IP address to be removed from the
ARP cache.
PE
arp resptime
Configures the ARP request response timeout.
GC
arp retries
Configures the ARP count of maximum request for retries. GC
arp timeout
Configures the ARP entry age-out time.
GC
clear arp-cache
Removes all ARP entries of type dynamic from the ARP
cache.
PE
ip proxy-arp
Enables proxy ARP on a router interface.
IC
show arp
Displays the Address Resolution Protocol (ARP) cache.
PE
show arp brief
Displays the brief Address Resolution Protocol (ARP) table
information.
PE
*NOTE:
For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command
Description
Mode*
bootpdhcprelay cidridoptmode
Enables the circuit ID option and remote agent ID mode
for BootP/DHCP Relay on the system.
GC
bootpdhcprelay enable
Enables the forwarding of relay requests for BootP/DHCP
Relay on the system.
GC
bootpdhcprelay maxhopcount
Configures the maximum allowable relay agent hops for
BootP/DHCP Relay on the system.
GC
bootpdhcprelay minwaittime
Configures the minimum wait time in seconds for
BootP/DHCP Relay on the system.
GC
bootpdhcprelay serverip
Configures the server IP address for BootP/DHCP Relay on
the system.
GC