Dell PowerEdge M805 - Manual (Page 750)

756 OSPFv3 Commands
www
.dell.com | support.dell.com
show ipv6 ospf neighbor
Use the show ipv6 ospf neighbor command in Privileged EXEC mode to display information about
OSPF neighbors. If a neighbor IP address is not specified, the output displays summary
information in a table. If an interface or tunnel is specified, only the information for that interface
or tunnel displays. The information below only displays if OSPF is enabled and the interface has a
neighbor.
Syntax
show ipv6 ospf neighbor [interface {vlan vlan-id | tunnel tunnel-id} [ip-address]
• vlan-id—Valid VLAN ID.
• tunnel-id—Tunnel identifier. (Range: 0-7)
• ip-address—Is the valid IP address of the neighbor about which information is displayed.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Examples
The following examples display information about OSPF neighbors, in the first case in a
summary table, and in the second in a table specific to tunnel 1.
console#show ipv6 ospf neighbor
Router ID Priority Intf Interface State Dead
ID Time
--------- -------- ---- ----------- ------------- ----
console#show ipv6 ospf neighbor interface tunnel 1
IP Address..................................... Err
ifIndex........................................ 619
OSPF Admin Mode................................ Enable
OSPF Area ID................................... 0.0.0.0
Router Priority................................ 1