Dell PowerEdge M805 - Manual (Page 675)

OSPF Commands 681
area stub
Use the area stub command in Router OSPF Configuration mode to create a stub area for the
specified area ID. A stub area is characterized by the fact that AS External LSAs are not propagated
into the area. Removing AS External LSAs and Summary LSAs can significantly reduce the link
state database of routers within the stub area. Use the no form of the command to remove the stub
area.
Syntax
area area-id stub
no area area-id stub
• area-id—Identifies the area identifier of the OSPF stub. (Range: IP address or decimal
from 0-4294967295)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode
User Guidelines
This command has no user guidelines.
Examples
The following examples define area 3 for the stub and then removes the stub area.
console(config-router)#area 3 stub
console(config-router)#no area 3 stub
area stub no-summary
Use the area stub no-summary command in Router OSPF Configuration mode to prevent
Summary LSAs from being advertised into the NSSA. Use the no form of the command to return
the Summary LSA mode to the default value.
Syntax
area area-id stub no-summary
no area area-id stub no-summary
• area-id—Identifies the OSPF area to configure. (Range: IP address or decimal from 0-
4294967295)