Dell PowerEdge M805 - Manual (Page 720)

726 OSPFv3 Commands
www
.dell.com | support.dell.com
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example prevents Summary LSAs from being advertised into the area 1 NSSA.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 stub no-summary
area virtual-link
Use the area virtual-link command in Router OSPFv3 Configuration mode to create the OSPF
virtual interface for the specified areaid and neighbor. Use the no area virtual-link command to
delete an OSPF virtual interface in an area.
Syntax
area areaid virtual-link neighbor-id
no area areaid virtual-link neighbor-id
• areaid—Valid OSPFv3 area identifier (or decimal value in the range of 0-4294967295).
• neighbor-id—Identifies the Router ID or IP address of the neighbor.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example creates the OSPF virtual interface for area 1 and its neighbor router.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2