Dell PowerEdge M805 - Manual (Page 123)

Management ACL Commands 87
Syntax
management access-list name
no management access-list name
• name—The access list name. (Range: 1 to 32 characters)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command enters the access-list configuration mode, where the denied or permitted
access conditions with the deny and permit commands must be defined.
If no match criteria are defined the default is deny.
If reentering to an access-list context, the new rules are entered at the end of the access-list.
Use the management access-class command to select the active access-list.
The active management list cannot be updated or removed.
Examples
The following example shows how to configure two management interfaces, Ethernet 1/g1
and Ethernet 2/g9.
console(config)#management access-list mlist
console(config-macal)# permit ethernet 1/g1 priority <1-64>
console(config-macal)# permit ethernet 2/g9 priority <1-64>
console(config-macal)# exit
console(config)#management access-class mlist
The following example shows how to configure all the interfaces to be management interfaces
except for two interfaces, Ethernet 1/g1 and Ethernet 2/g9.
console(config)# management access-list mlist
console(config-macal)# deny ethernet 1/g1 priority <1-64>
console(config-macal)# deny ethernet 2/g9 priority <1-64>
console(config-macal)# permit priority <1-64>
console(config-macal)# exit
console(config) # management access-class mlist