Dell PowerEdge M805 - Manual (Page 513)

Telnet Server Commands 509
Telnet Server Commands
ip telnet server disable
This command is used to enable/disable the Telnet service on the switch.
ip telnet server disable
no ip telnet server disable
Syntax Description
Not applicable
Parameter Ranges
Not applicable
Command Mode
Global Configuration
Usage Guidelines
No specific guidelines.
Default Value
This feature is enabled by default.
Example
console#configure
console(config)#ip telnet server disable
console(config)# no ip telnet server disable
ip telnet port
This command is used to configure the Telnet service port number on the switch.