Dell PowerEdge M805 - Manual (Page 94)

56 Using the CLI
www
.dell.com | support.dell.com
• Policy-map—Use the policy-map command to access the QoS policy map configuration
mode to configure the QoS policy map.
• Policy Class—Use the class command to access the QoS Policy-class mode to attach or
remove a diffserv class from a policy and to configure the QoS policy class.
• Class-Map—This mode consists of class creation/deletion and matching commands. The
class matching commands specify layer 2, layer 3 and general match criteria. Use the class-
map class-map-name commands to access the QoS Class Map Configuration mode to
configure QoS class maps.
• Stack—Use the stack command to access the Stack Configuration Mode.
• Ethernet—Contains commands to manage Ethernet port configuration. The Global
Configuration mode command interface ethernet enters the Interface Configuration mode
to configure an Ethernet interface.
• Port Channel—Contains commands to configure port-channels, i.e., assigning ports to a
port-channel. Most of these commands are the same as the commands in the Ethernet
interface mode and are used to manage the member ports as a single entity. The Global
Configuration mode command interface port-channel is used to enter the Port Channel
mode.
• Tunnel-Contains commands to manage tunnel interfaces. The Global Configuration mode
command interface tunnel enters the Tunnel Configuration mode to configure an tunnel type
interface.
• Loopback-Contains commands to manage loopback interfaces. The Global Configuration
mode command interface loopback enters the Loopback Configuration mode to configure an
loopback type interface.
• SSH Public Key-chain—Contains commands to manually specify other switch SSH public
keys. The Global Configuration mode command crypto key pub-key chain ssh is used to
enter the SSH Public Key-chain configuration mode.
• SSH Public Key-string—Contains commands to manually specify the SSH Public-key of a
remote SSH Client. The SSH Public-Key Chain Configuration mode command user-key
command is used to enter the SSH Public-Key Configuration mode
.
• MAC Access-List—Configures conditions required to allow traffic based on MAC addresses.
The Global Configuration mode command mac-access-list is used to enter the MAC Access-
List configuration mode.
• TACACS— Configures the parameters for the TACACS server.
• Radius— Configures the parameters for the RADIUS server.
• SNMP Host Configuration— Configures the parameters for the SNMP server host.
• SNMP v3 Host Configuration—Configures the parameters for the SNMP v3 server host.
• SNMP Community Configuration—Configures the parameters for the SNMP server
community.