Dell PowerEdge M805 - Manual (Page 445)

SNMP Commands 437
snmp-server trap authentication
Use the snmp-server trap authentication command in Global Configuration mode to enable the
switch to send Simple Network Management Protocol traps when authentication fails. To disable
SNMP failed authentication traps, use the no form of this command.
Syntax
snmp-server trap authentication
no snmp-server trap authentication
Default Configuration
Traps are enabled by default.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the command to enable authentication failed SNMP traps.
console(config)# snmp-server trap authentication
snmp-server user
Use the snmp-server user command in Global Configuration mode to configure a new SNMP
Version 3 user. To delete a user, use the no form of this command.
Syntax
snmp-server user username groupname [remote engineid-string] [ { auth-md5 password |
auth-sha password | auth-md5-key md5-key | auth-sha-key sha-key } [priv-des password |
priv-des-key des-key] ]
no snmp-server user username
• username—Specifies the name of the user on the host that connects to the agent. (Range:
1-30 characters.)
• groupname—Specifies the name of the group to which the user belongs. (Range: 1-30
characters.)