Dell PowerEdge M805 - Manual (Page 728)

734 OSPFv3 Commands
www
.dell.com | support.dell.com
ipv6 ospf
Use the ipv6 ospf command in Interface Configuration mode to enable OSPF on a router interface
or loopback interface.
Syntax
ipv6 ospf
no ipv6 ospf
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example enables OSPF on VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf
ipv6 ospf areaid
Use the ipv6 ospf areaid command in Interface Configuration mode to set the OSPF area to which
the specified router interface belongs.
Syntax
ipv6 ospf areaid areaid
no ipv6 ospf areaid areaid
• areaid—Is a 32-bit integer, formatted as a 4-digit dotted-decimal number or a decimal
value. It uniquely identifies the area to which the interface connects. Assigning an area id
which does not exist on an interface causes the area to be created with default values.
(Range: 0-4294967295).
Default Configuration
This command has no default configuration.