Dell PowerEdge M805 - Manual (Page 194)

162 Ethernet Configuration Commands
www
.dell.com | support.dell.com
State
---- ---- ------ ----- ---- -----
1 1000 Full 1000 Off Up
*: The interface was suspended by the system.
The displayed port status information includes the following:
show statistics ethernet
Use the show statistics ethernet command in Privileged EXEC mode to display detailed statistics
for a specific port or for the entire switch.
Syntax
show statistics ethernet { <unit>/<port-type><port> | switchport }
• <unit>/<port-type><port>—Displays statistics for a valid unit/port:
<unit>—Physical switch identifier within the stack. Values are 1-12.
<port-type>— Values are g for gigabit Ethernet port, or xg for 10 gigabit Ethernet port.
<port>—port number. Values are 1-24 or 1-48 in the case of port_type g, and 1-4 for
port_type xg.
Example: xg2 is the 10 gigabit Ethernet port 2.
• switchport—Displays statistics for the entire switch.
Default Configuration
This command has no default configuration.
Field Description
Port The port number.
Type The port designated IEEE shorthand identifier. For example 1000Base-T refers
to 1000 Mbps baseband signaling including both Tx and Rx transmissions.
Duplex Displays the port Duplex status.
Speed Refers to the port speed.
Neg Describes the Auto-negotiation status.
MDIX Mode Displays the Auto-crossover status.
Link State Displays the Link Aggregation status.