Dell PowerEdge M805 - Manual (Page 722)

728 OSPFv3 Commands
www
.dell.com | support.dell.com
• seconds—Hello interval. (Range: 1-65535)
Default Configuration
10 is the default value for seconds.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures a hello interval of 20 seconds for the OSPF virtual interface
on the virtual interface identified by area 1 and its neighbor.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2 hello-interval 20
area virtual-link retransmit-interval
Use the area virtual-link retransmit-interval command in Router OSPFv3 Configuration mode to
configure the retransmit interval for the OSPF virtual interface on the virtual interface identified
by areaid and neighbor.
Syntax
area areaid virtual-link neighbor retransmit-interval seconds
no area areaid virtual-link neighbor retransmit-interval
• areaid—Valid OSPFv3 area identifier.
• neighbor—Router ID of neighbor.
• seconds—Retransmit interval. (Range: 0-3600)
Default Configuration
5 is the default value for seconds.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.