Tunnel interface commands, Interface tunnel, Show interfaces tunnel – Dell PowerEdge M805 User Manual
Page 793: 56 tunnel interface commands
Tunnel Interface Commands
803
Tunnel Interface Commands
interface tunnel
Use the interface tunnel command in Global Configuration mode to enter the interface
configuration mode for a tunnel.
Syntax
interface tunnel tunnel-id
no interface tunnel tunnel-id
•
tunnel-id—Tunnel identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example enables the interface configuration mode for tunne1 1.
console(config)#interface tunnel 1
console(config-if-tunnel1)#
show interfaces tunnel
Use the show interfaces tunnel command in Privileged EXEC mode to display the parameters
related to tunnel such as tunnel mode, tunnel source address and tunnel destination address.