Dell PowerEdge M805 - Manual (Page 124)

88 Management ACL Commands
www
.dell.com | support.dell.com
permit (management)
Use the permit command in Management Access-List configuration mode to set conditions for the
management access list.
Syntax
permit [ethernet interface-number | vlan vlan-id | port-channel number] [service service]
[priority priority-value]
permit ip-source ip-address [mask mask | prefix-length] [ethernet interface-number | vlan
vlan-id |port-channel number] [service service] [priority priority-value]
• ethernet interface-number—A valid routed port number.
• vlan vlan-id—A valid VLAN number.
• port-channel number—A valid port channel number.
• ip-address—Source IP address.
• mask mask—Specifies the network mask of the source IP address.
• mask prefix-length—Specifies the number of bits that comprise the source IP address
prefix. The prefix length must be preceded by a forward slash (/). (Range: 0-32)
• service service—Indicates service type. Can be one of the following: telnet, ssh, http,
https or snmp.
• priority priority-value—Priority for the rule. (Range: 1 - 64)
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
User Guidelines
Rules with ethernet, vlan, and port-channel parameters are valid only if an IP address is
defined on the appropriate interface. Ensure that each rule has a unique priority.
Examples
The following example shows how to configure two management interfaces, Ethernet 1/g1
and Ethernet 2/g9.
console(config)#management access-list mlist
console(config-macal)# permit ethernet 1/g1 priority <1-64>
console(config-macal)# permit ethernet 2/g9 priority <1-64>
console(config-macal)# exit
console(config)# management access-class mlist