Dell PowerEdge M805 - Manual (Page 753)

OSPFv3 Commands 759
Example
The following example displays the OSPF Virtual Interface information for area 1 and its
neighbor.
console#show ipv6 ospf virtual-link 1 1.1.1.1
Area ID........................................ 1
Neighbor Router ID............................. 1.1.1.1
Hello Interval................................. 10
Dead Interval.................................. 40
Iftransit Delay Interval....................... 1
Retransmit Interval............................ 5
State.......................................... point-to-point
Metric......................................... 10
Neighbor State................................. Full
show ipv6 ospf virtual-link brief
Use the show ipv6 ospf virtual-link brief command in Privileged EXEC mode to display the
OSPFV3 Virtual Interface information for all areas in the system.
Syntax
show ipv6 ospf virtual-link brief
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF stub table.
console(config)#show ipv6 ospf virtual-link brief
Hello Dead Retransmit Transit
Area ID Neighbor Interval Interval Interval Delay
----------- ----------- ---------- ---------- ---------- --------