Dell PowerEdge M805 - Manual (Page 535)

VLAN Commands 531
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example assigns the name "protected" to group 1.
console(config-if-1/g1)#switchport protected 1 name protected
switchport trunk allowed vlan
Use the switchport trunk allowed vlan command in Interface Configuration mode to add VLANs
to or remove VLANs from a trunk port.
Syntax
switchport trunk allowed vlan {add vlan-list|remove vlan-list}
• add vlan-list—List of VLAN IDs to add. Separate non-consecutive VLAN IDs with a
comma and no spaces. Use a hyphen to designate a range of IDs.
• remove vlan-list—List of VLAN IDs to remove. Separate non-consecutive VLAN IDs
with a comma and no spaces. Use a hyphen to designate a range of IDs.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how to add VLANs 1, 2, and 5 to 8 to the allowed list.
console(config-if-1/g8)#switchport trunk allowed vlan add 1,2,5-8