Dell PowerEdge M805 - Manual (Page 269)

System Management Commands 247
System Management Commands
asset-tag
Use the asset-tag command in Global Configuration mode to specify the switch asset tag. To
remove the existing asset tag, use the no form of the command.
Syntax
asset-tag [unit] tag
no asset-tag [unit]
• unit—Switch number. (Range: 1–12)
• tag—The switch asset tag.
Default Configuration
No asset tag is defined by default.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example specifies the switch asset tag as "1qwepot." Because the unit
parameter is not specified, the command defaults to the master switch number.
console(config)# asset-tag 1qwepot
cut-through mode
Use the cut-through mode command to enable the cut-through mode on the switch. The mode
takes effect on all ports on next reload of the switch.