Dell PowerEdge M805 - Manual (Page 76)

38 Command Groups
www
.dell.com | support.dell.com
Loopback Interface Commands
Multicast Commands
show ipv6 route preference Shows the preference value associated with the type of
route. PE
show ipv6 route summary Displays a summary of the routing table. PE
show ipv6 traffic Shows traffic and statistics for IPv6 and ICMPv6. UE
show ipv6 vlan Displays IPv6 VLAN routing interface addresses. PE
traceroute ipv6 Discovers the routes that packets actually take when
traveling to their destination through the network on a
hop-by-hop basis. PE
*NOTE: For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command Description Mode*
interface loopback Enters the Interface Loopback configuration mode. GC
show interface loopback Displays information about configured loopback interfaces. PE
*NOTE: For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command Description Mode*
ip mcast boundary Adds an administrative scope multicast boundary. IC
ip multicast Sets the administrative mode of the IP multicast forwarder
in the router to active. GC
ip multicast staticroute Creates a static route which is used to perform RPF
checking in multicast packet forwarding. GC
ip multicast ttl-threshold Applies a ttlvalue to a routing interface. IC
mrinfo Queries the neighbor information for a multicast-
capable router specified by ipaddr. PE
mstat Finds the IP Multicast packet rate and loss information
path from a source to a receiver. PE
mtrace Finds the IP Multicast path from a source to a receiver. PE
no ip mcast mroute Clears entries in the mroute table. GC
show ip mcast Displays the system-wide multicast information. PE
show ip mcast boundary Displays the system-wide multicast information. PE
Command Description Mode*