Dell PowerEdge M805 - Manual (Page 393)

QoS Commands 381
63 3
console#
show classofservice trust
Use the show classofservice trust command in Privileged EXEC mode to display the current trust
mode setting for a specific interface.
Syntax
show classofservice trust [<unit>/<port-type><port>|port-channel port-channel number]
• <unit>/<port-type><port>—Specifies a valid unit/port combination:
<unit>—Physical switch identifier within the stack. Values are 1-12.
<port-type>— Values are g for gigabit Ethernet port, or xg for 10 gigabit Ethernet port.
<port>—port number. Values are 1-24 or 1-48 in the case of port_type g, and 1-4 for
port_type xg.
Example: xg2 is the 10 gigabit Ethernet port 2.
• port-channel number—Specifies a valid port-channel number. Range is 1-8.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
If the interface is specified, the port trust mode of the interface is displayed. If omitted, the
port trust mode for global configuration is shown.
Example
The following example displays the current trust mode settings for the specified port.
console#show classofservice trust 1/g2
Class of Service Trust Mode: Dot1P
show diffserv
Use the show diffserv command in Privileged EXEC mode to display the DiffServ general
information, which includes the current administrative mode setting as well as the current and
maximum number of DiffServ components.