Dell PowerEdge M805 - Manual (Page 786)

794 Routing Information Protocol (RIP) Commands
www
.dell.com | support.dell.com
no ip rip authentication
• key—Authentication key for the specified interface. (Range: 16 bytes or less)
• encrypt—Specifies the Ethernet unit/port of the interface to view information.
• key-id—Authentication key identifier for authentication type encrypt. (Range: 0-255)
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the RIP Version 2 Authentication Type and Key for VLAN 11.
console(config-if-vlan11)#ip rip authentication encrypt pass123 35
ip rip receive version
Use the ip rip receive version command in Interface Configuration mode to configure the interface
to allow RIP control packets of the specified version(s) to be received. Use the no form of the
command to return the version to the default value.
Syntax
ip rip receive version {rip1 | rip2 | both | none}
no ip rip receive version
• rip1—Receive only RIP version 1 formatted packets.
• rip2—Receive only RIP version 2 formatted packets.
• both—Receive packets from either format.
• none—Do not allow any RIP control packets to be received.
Default Configuration
Both is the default configuration.
Command Mode
Interface Configuration (VLAN) mode.