Dell PowerEdge M805 - Manual (Page 511)

TACACS+ Commands 507
tacacs-server timeout
Use the tacacs-server timeout command in Global Configuration mode to set the interval during
which a switch waits for a server host to reply. To restore the default, use the no form of this
command.
Syntax
tacacs-server timeout timeout
no tacacs-server timeout
• timeout—The timeout value in seconds. (Range: 1 - 30)
Default Configuration
The default value is 5 seconds.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the timeout value as 30.
console(config)#tacacs-server timeout 30
timeout
Use the timeout command in TACACS Configuration mode to specify the timeout value in
seconds. If no timeout value is specified, the global value is used.
Syntax
timeout timeout
• timeout—The timeout value in seconds. (Range: 1 - 30)
Default Configuration
If left unspecified, the timeout defaults to the global value.
Command Mode
TACACS Configuration mode
User Guidelines
This command has no user guidelines.