Dell PowerEdge M805 - Manual (Page 364)

350 Configuration and Image File Commands
www
.dell.com | support.dell.com
exit
interface ethernet 1/g2
ip address 176.243.100.100 255.255.255.0
duplex full
speed 1000
exit
update bootcode
Use the update bootcode command in Privileged EXEC mode to update the bootcode on one or
more switches. For each switch, the bootcode is extracted from the active image and programmed
to flash.
Syntax
update bootcode [unit ]
• unit —Unit number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
If unit is not specified, all units are updated.
Example
The following example updates the bootcode on unit 2.
console#update bootcode 2