Dell PowerEdge M805 - Manual (Page 107)

Using the CLI 69
Now we need to configure your initial privilege (Level 15) user
account. This account is used to login to the CLI and Web
interface. You may set up other accounts and change privilege
levels later. For more information on setting up user accounts and
changing privilege levels, see the User’s Guide.
To set up a user account:
Type the user name [admin]: admin<Return>
Type the user password: ********<Return>
Type the user password again: ********<Return>
NOTE: If the first and second password entries are not identical,
the user is prompted until they are.
NOTE: You can create additional user accounts after completing the
Easy Setup Wizard. See the User’s Guide for more information.
Step 3:
Next, an IP address is set up. The IP address is defined on the
default VLAN (VLAN #1), of which all ports are members. This is the
IP address you use to access the CLI, Web interface, or SNMP
interface for the switch. Optionally you may request that the
system automatically retrieve an IP address from the network using
DHCP (this option requires that you have a DHCP server running on
the network).
To set up an IP address:
Type the IP address of the device (A.B.C.D) or enter "DHCP"
(without the quotation marks) to automatically request an IP
address from the network DHCP server. [192.168.2.1].
Type the IP subnet mask (A.B.C.D or /nn). [255.255.255.0]
Step 4:
Finally, set up the default gateway. Type the IP address of the
gateway from which this network is reachable [0.0.0.0]:
This is the configuration information that has been collected:
User Account set up = admin
Password = ********
Management IP address = 192.168.2.1 255.255.255.0
Default Gateway = 0.0.0.0