Show ip igmp, Show ip igmp groups – Dell PowerEdge M805 User Manual
Page 597
IGMP Commands
601
console#interface vlan 15
console(config-if-vlan15)#ip igmp version 2
show ip igmp
Use the show ip igmp command in Privileged EXEC mode to display system-wide IGMP
information.
Syntax
show ip igmp
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays system-wide IGMP information .
console#show ip igmp groups vlan 2
IP Address..................................... 1.1.1.1
Subnet Mask.................................. 255.255.255.0
Interface Mode............................... Enable
Querier Status................................ Querier
show ip igmp groups
Use the show ip igmp groups command in Privileged EXEC mode to display the registered
multicast groups on the interface. If detail is specified, this command displays the registered
multicast groups on the interface in detail.
Syntax
show ip igmp groups vlan vlan-id [detail]
•
vlan-id—Valid VLAN ID