Dell PowerEdge M805 - Manual (Page 688)

694 OSPF Commands
www
.dell.com | support.dell.com
ip ospf dead-interval
Use the ip ospf dead-interval command in Interface Configuration to set the OSPF dead interval
for the specified interface. Use the no form of the command to return the interval to the default
value.
Syntax
ip ospf dead-interval seconds
no ip ospf dead-interval
• seconds—Number of seconds that a router's Hello packets have not been seen before its
neighbor routers declare that the router is down. (Range: 1-65535)
Default Configuration
40 is the default number of seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
The value for the length of time must be the same for all routers attached to a common
network. This value should be some multiple of the Hello Interval (i.e. 4).
Example
The following example sets the dead interval at 30 seconds.
console(config-if-vlan15)#ip ospf dead-interval 30
ip ospf hello-interval
Use the ip ospf hello-interval command in Interface Configuration mode to set the OSPF hello
interval for the specified interface. Use the no form of the command to return the interval to the
default value.
Syntax
ip ospf hello-interval seconds
no ip ospf hello-interval
• seconds—Number of seconds to wait before sending Hello packets from the interface.
(Range: 1-65535)
Default Configuration
10 is the default number of seconds.