Show ipv6 ospf database – Dell PowerEdge M805 User Manual
Page 740
746
OSPFv3 Commands
www
.dell.com | support.dell.com
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
console#show ipv6 ospf asbr
Type Router Id Cost Area ID Next Hop Next Hop
Intf
---- --------- ---- -------- ----------------------- -------
INTRA
1.1.1.1
10 0.0.0.1 FE80::213:C4FF:FEDB:6C41 vlan10
INTRA
4.4.4.4
10 0.0.0.1 FE80::210:18FF:FE82:8E1 vlan12
show ipv6 ospf database
Use the show ipv6 ospf database command in Privileged EXEC mode to display information about
the link state database when OSPFv3 is enabled. If no parameters are entered, the command
displays the LSA headers. Optional parameters specify the type of link state advertisements to
display.
The information below is only displayed if OSPF is enabled.
Syntax
show ipv6 ospf [areaid] database [{external | inter-area {prefix | router} | link | network |
nssa-external | prefix | router | unknown [area | as | link]}] [lsid] [adv-router [rtrid] | self-
originate]
•
areaid—Identifies a specific OSPF area for which link state database information will be
displayed.
•
external—Displays the external LSAs.
•
inter-area—Displays the inter-area LSAs.
•
link—Displays the link LSAs.
•
network—Displays the network LSAs.
•
nssa-external—Displays NSSA external LSAs.
•
prefix—Displays intra-area Prefix LSA.
•
router—Displays router LSAs.