Dell PowerEdge M805 - Manual (Page 782)

790 Routing Information Protocol (RIP) Commands
www
.dell.com | support.dell.com
Default Configuration
This command has no default configuration.
Command Mode
Router RIP Configuration mode
User Guidelines
This command has no user guidelines.
Example
console(config-router)#default-information originate
default-metric
Use the default-metric command in Router RIP Configuration mode to set a default for the metric
of distributed routes. Use the no form of the command to return the metric to the default value.
Syntax
default-metric integer
no default-metric
• integer—Metric for the distributed routes. (Range: 1-15)
Default Configuration
Default metric is not configured by default.
Command Mode
Router RIP Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets a default of 12 for the metric of distributed routes.
console(config-router)#default-metric 12
distance rip
Use the distance rip command in Router RIP Configuration mode to set the route preference value
of RIP in the router. Lower route preference values are preferred when determining the best route.
Use the no form of the command to return the preference to the default value.