Dell PowerEdge M805 - Manual (Page 202)

170 Ethernet Configuration Commands
www
.dell.com | support.dell.com
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
console(config-if-1/g1)#storm-control multicast level 5
storm-control unicast
Use the storm-control unicast command in Interface Configuration mode to enable unknown
unicast storm control for an interface. If the mode is enabled, unicast storm recovery is active, and
if the rate of unknown L2 unicast (destination lookup failure) traffic ingressing on an interface
increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of
unknown unicast traffic will be limited to the configured threshold.
Syntax
storm-control unicast [level rate]
no storm-control unicast
• rate—Maximum packets per second of unicast traffic on a port. (Range: 0-100)
Default Configuration
The default value is 5.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
console(config-if-1/g1)#storm-control unicast level 5