Management acl commands, Deny (management) – Dell PowerEdge M805 User Manual
Page 121
Management ACL Commands
85
Management ACL Commands
deny (management)
Use the deny command in Management Access-List Configuration mode to set conditions for the
management access list.
Syntax
deny [ethernet interface-number | vlan vlan-id | port-channel number] [service service]
[priority priority]
deny ip-source ip-address [mask mask | prefix-length] [ethernet interface-number | vlan vlan-
id | port-channel number] [service service] [priority priority]
•
ethernet interface-number—A valid Ethernet-routed port number.
•
vlan vlan-id—A valid VLAN number.
•
port-channel number—A valid routed port-channel number.
•
ip-address—Source IP address.
•
mask mask—Specifies the network mask of the source IP address.
•
mask prefix-length—Specifies the number of bits that comprise the source IP address
prefix. The prefix length must be preceded by a forward slash (/). (Range: 0-32)
•
service service—Indicates service type. Can be one of the following: telnet, ssh, http,
https or snmp.
•
priority priority—Priority for the rule. (Range: 1 - 64)
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode