Dell PowerEdge M805 - Manual (Page 666)

672 Multicast Commands
www
.dell.com | support.dell.com
Syntax
show mrinfo
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the static routes configured in the static mcast table.
console#show mrinfo
Results for 'show mrinfo'
0.0.0.0 [Flags: ]
Router Interface Neighbor Metric TTL Flags
-------- --------- ------ ------ ----------
show mstat
Use the show mstat command in Privileged EXEC mode to display the results of packet rate and
loss information from the results buffer pool of the router after execution/completion of a mstat
command. Within two minutes of completing the mstat command, the results are available in the
buffer pool. The next mstat command overwrites the buffer pool with fresh results.
Syntax
show mstat
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.