Dell PowerEdge M805 - Manual (Page 684)

690 OSPF Commands
www
.dell.com | support.dell.com
Example
The following example enables OSPF router mode.
console(config-router)#enable
exit-overflow-interval
Use the exit-overflow-interval command in Router OSPF Configuration mode to configure the
exit overflow interval for OSPF. When a router leaves the overflow state it can originate non-
default AS-external-LSAs. When set to 0, the router will not leave Overflow State until restarted.
Use the no form of the command to return the interval to the default value.
Syntax
exit-overflow-interval seconds
no exit-overflow-interval
• seconds—Number of seconds after entering overflow state that a router will wait before
attempting to leave the overflow state. (Range: 0-2147483647)
Default Configuration
0 seconds is the default configuration.
Command Mode
Router OSPF Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the exit overflow interval for OSPF at 10 seconds.
console(config-router)#exit-overflow-interval 10
external-lsdb-limit
Use the external-lsdb-limit command in Router OSPF Configuration mode to configure the
external LSDB limit for OSPF. If the value is -1, then there is no limit. When the number of non-
default AS-external-LSAs in a router's link-state database reaches the external LSDB limit, the
router enters overflow state. The router never holds more than the external LSDB limit non-default
AS-external-LSAs in it database. Use the no form of the command to return the limit to the default
value.
Syntax
external-lsdb-limit integer