Dell PowerEdge M805 - Manual (Page 603)

IGMP Proxy Commands 607
IGMP Proxy Commands
ip igmp-proxy
Use the ip igmp-proxy command in Interface Configuration mode to enable the IGMP Proxy on
the router. To enable the IGMP Proxy on the router, multicast forwarding must be enabled and
there must be no multicast routing protocols enabled on the router.
Syntax
ip igmp-proxy
no ip igmp-proxy
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example enables the IGMP Proxy on the VLAN 15 router.
console(config)#interface vlan 15
console(config-if-vlan15)#ip igmp-proxy
ip igmp-proxy reset-status
Use the ip igmp-proxy reset-status command in Interface Configuration mode to reset the host
interface status parameters of the IGMP Proxy router. This command is valid only when IGMP
Proxy is enabled on the interface.