Dell PowerEdge M805 - Manual (Page 75)

Command Groups 37
ipv6 enable Enables IPv6 routing on an interface (including tunnel and
loopback interfaces) that has not been configured with an
explicit IPv6 address. IC
ipv6 forwarding Enables IPv6 forwarding on a router. GC
ipv6 mtu Sets the maximum transmission unit (MTU) size, in bytes,
of IPv6 packets on an interface. IC
ipv6 nd dad attempts Sets the number of duplicate address detection probes
transmitted while doing neighbor discovery. IC
ipv6 nt managed-config-flag Sets the “managed address configuration” flag in router
advertisements. IC
ipv6 nd ns-interval Sets the interval between router advertisements for
advertised neighbor solicitations. IC
ipv6 nd other-config-flag Sets the “other stateful configuration” flag in router
advertisements sent from the interface. IC
ipv6 nd prefix Set the IPv6 prefixes to include in the router
advertisement. IC
ipv6 nd ra-interval Sets the transmission interval between router
advertisements. IC
ipv6 nd ra-lifetime Sets the value that is placed in the Router Lifetime field of
the router advertisements sent from the interface. IC
ipv6 nd reachable-time Sets the router advertisement time to consider a neighbor
reachable after neighbor discovery confirmation. IC
ipv6 nd suppress-ra Suppresses router advertisement transmission on an
interface. IC
ipv6 route Configures an IPv6 static route GC
ipv6 route distance Sets the default distance (preference) for static routes. GC
ipv6 unicast-routing Enables forwarding of IPv6 unicast datagrams. GC
ping ipv6 Determines whether another computer is on the network. PE
ping ipv6 interface Determines whether another computer is on the network
using Interface keyword. PE
show ipv6 brief Displays the IPv6 status of forwarding mode and IPv6
unicast routing mode. PE
show ipv6 interface Shows the usability status of IPv6 interfaces. PE
show ipv6 neighbors Displays information about the IPv6 neighbors. PE
show ipv6 route Displays the IPv6 routing table. PE
Command Description Mode*