Dell PowerEdge M805 - Manual (Page 659)

Multicast Commands 665
Example
The following example clears entries in the mroute table.
console(config)#no ip mcast mroute all
show ip mcast
Use the show ip mcast command in Privileged EXEC mode to display the system-wide multicast
information.
Syntax
show ip mcast
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays system-wide multicast information.
console#show ip mcast
Admin Mode..................................... Disable
Protocol State................................. Non-Operational
Table Max Size ................................ 256
Number Of Packets For Which Source Not Found .. 0
Number Of Packets For Which Group Not Found ... 0
Protocol....................................... No Protocol
Enabled
Entry Count ................................... 0
Highest Entry Count ........................... 0
show ip mcast boundary
Use the show ip mcast boundary command in Privileged EXEC mode to display all the configured
administrative scoped multicast boundaries.