Dell PowerEdge M805 - Manual (Page 204)

174 GVRP Commands
www
.dell.com | support.dell.com
no garp timer
• join—Indicates the time in centiseconds that PDUs are transmitted.
• leave—Indicates the time in centiseconds that the device waits before leaving its GARP
state.
• leaveall—Used to confirm the port within the VLAN. The time is the interval between
messages sent, measured in centiseconds.
• timer_value—Timer values in centiseconds. The range is 10-100 for join, 30-600 for leave,
and 200-6000 for leaveall.
Default Configuration
The default timer values are as follows:
• Join timer—20 centiseconds
• Leave timer—60 centiseconds
• Leaveall timer—1000 centiseconds
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode
User Guidelines
The following relationships for the various timer values must be maintained:
• Leave time must be greater than or equal to three times the join time.
• Leaveall time must be greater than the leave time.
Set the same GARP timer values on all Layer 2-connected devices. If the GARP timers are set
differently on Layer 2-connected devices, the GARP application will not operate successfully.
The timer_value setting must be a multiple of 10.
Example
The following example sets the leave timer for port 1/g8 to 90 centiseconds.
console (config)# interface ethernet 1/g8
console (config-if-1/g8)# garp timer leave 90
gvrp enable (global)
Use the gvrp enable (global) command in Global Configuration mode to enable GVRP globally on
the switch. To disable GVRP globally on the switch, use the no form of this command.