Dell PowerEdge M805 - Manual (Page 227)

IGMP Snooping Querier Commands 199
continues sending periodic queries. The no form of this command sets the snooping querier not to
participate in the querier election but to go into a non-querier mode as soon in as it discovers the
presence of another querier in the same VLAN.
Syntax
ip igmp snooping querier election participate vlan-id
no ip igmp snooping querier election participate vlan-id
Default Configuration
The snooping querier is configured to not participate in the querier election by default.
Command Mode
VLAN Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the snooping querier to participate in the querier election.
console(config-vlan)#ip igmp snooping querier election participate
show igmpsnooping querier
This command displays IGMP Snooping Querier information. Configured information is displayed
whether or not IGMP Snooping Querier is enabled.
When the optional argument vlanid is not used, the command shows the following information:
• Admin Mode —Indicates whether or not IGMP Snooping Querier is active on the switch.
• Admin Version— Indicates the version of IGMP that will be used while sending out the
queries.
• Source IP Address—Shows the IP address that is used in the IPv4 header when sending out
IGMP queries. It can be configured using the appropriate command.
• Query Interval—Shows the amount of time in seconds that a Snooping Querier waits before
sending out the periodic general query
• Querier Timeout—Displays the amount of time to wait in the Non-Querier operational state
before moving to a Querier state.
When you specify a value for vlanid, the following additional information appears:
• VLAN Admin Mode—Indicates whether IGMP Snooping Querier is active on the VLAN.