Dell PowerEdge M805 - Manual (Page 360)

346 Configuration and Image File Commands
www
.dell.com | support.dell.com
console#show backup-config
software version 1.1
hostname device
interface ethernet 1/g1
ip address 176.242.100.100 255.255.255.0
duplex full
speed 1000
exit
interface ethernet 1/g2
ip address 176.243.100.100 255.255.255.0
duplex full
speed 1000
exit
show bootvar
Use the show bootvar command in User EXEC mode to display the active system image file that
the device loads at startup.
Syntax
show bootvar [unit ]
• unit—-Unit number.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the active system image file that the device loads at startup.
console>show bootvar