Dell PowerEdge M805 - Manual (Page 785)

Routing Information Protocol (RIP) Commands 793
Default Configuration
Enabled is the default configuration.
Command Mode
Router RIP Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config-router)#hostroutesaccept
ip rip
Use the ip rip command in Interface Configuration mode to enable RIP on a router interface. Use
the no form of the command to disable RIP on the interface.
Syntax
ip rip
no ip rip
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
console(config-if-vlan2)#ip rip
console(config-if-vlan2)#no ip rip
ip rip authentication
Use the ip rip authentication command in Interface Configuration Mode to set the RIP Version 2
Authentication Type and Key for the specified interface. Use the no form of the command to
return the authentication to the default value.
Syntax
ip rip authentication {none | {simple key} | {encrypt key key-id}}