Dell PowerEdge M805 - Manual (Page 378)

366 QoS Commands
www
.dell.com | support.dell.com
match dstl4port
Use the match dstl4port command in Class-Map Configuration mode to add to the specified class
definition a match condition based on the destination layer 4 port of a packet using a single
keyword or a numeric notation.
Syntax
match dstl4port {portkey|port-number}
• portkey—Specifies one of the supported port name keywords. A match condition is
specified by one layer 4 port number. The currently supported values are: domain, echo,
ftp, ftpdata, http, smtp,snmp, telnet, tftp, and www.
• port-number—Specifies a layer 4 port number (Range: 0–65535).
Default Configuration
This command has no default configuration.
Command Mode
Class-Map configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays adding a match condition based on the destination layer 4
port of a packet using the "echo" port name keyword.
console(config-classmap)#match dstl4port echo
match ethertype
Use the match ethertype command in Class-Map Configuration mode to add to the specified class
definition a match condition based on the value of the ethertype.
Syntax
match ethertype {keyword|<0x0600-0xffff> }
• keyword—Specifies either a valid keyword or a valid hexadecimal number. The supported
keywords are appletalk, arp, ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios,
novell, pppoe, rarp. (Range: 0x0600 - 0xFFFF)
Default Configuration
This command has no default configuration.