Dell PowerEdge M805 - Manual (Page 520)

516 VLAN Commands
www
.dell.com | support.dell.com
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to add a physical port interface to the group ID of "2."
console(config-if-1/g1)#protocol vlan group 2
protocol vlan group all
Use the protocol vlan group all command in Global Configuration mode to add all physical
interfaces to the protocol-based group identified by groupid. A group may have more than one
interface associated with it. Each interface and protocol combination can be associated with one
group only. If adding an interface to a group causes any conflicts with protocols currently associated
with the group, this command fails and the interface(s) are not added to the group. Ensure that the
referenced VLAN is created prior to the creation of the protocol-based group except when GVRP is
expected to create the VLAN.
To remove all interfaces from this protocol-based group that is identified by this groupid, use the
no form of the command
Syntax
protocol vlan group all groupid
no protocol vlan group all groupid
• groupid—The protocol-based VLAN group ID, which is automatically generated when
you create a protocol-based VLAN group with the vlan protocol group command. To see
the group ID associated with the name of a protocol group, use the show port protocol all
command.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.