Dell PowerEdge M805 - Manual (Page 398)

386 QoS Commands
www
.dell.com | support.dell.com
The following table lists the parameters in the examples and gives a description of each.
show policy-map
Use the show policy-map command in Privileged EXEC mode to display all configuration
information for the specified policy.
Syntax
show policy-map [policyname]
• policyname—Specifies the name of a valid existing DiffServ policy. (Range: 1-31)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
Parameter Description
Interface The port of the interface. If displaying the global
configuration, this output line is replaced with a global
configuration indication.
Intf Shaping Rate The maximum transmission bandwidth limit for the
interface as a whole. It is independent of any
per-queue maximum bandwidth values in effect for
the interface. This value is a configured value.
Queue Mgmt Type The queue depth management technique used for all
queues on this interface.
Queue An interface supports n queues numbered 0 to
( n-1).The specific n value is platform-dependent.
Internal egress queue of the interface; queues 0–6 are
available.
Minimum Bandwidth The minimum transmission bandwidth guarantee for
the queue, expressed as a percentage. A value of 0
means bandwidth is not guaranteed and the queue
operates using best-effort. This value is a configured
value.
Scheduler Type Indicates whether this queue is scheduled for
transmission using a strict priority or a weighted
scheme. This value is a configured value.