Dell PowerEdge M805 - Manual (Page 247)

LLDP Commands 219
Syntax
lldp transmit
no lldp transmit
Default Configuration
LLDP is disabled on all supported interfaces.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how enable the transmission of local data.
console(config-if-1/g3)#lldp transmit
lldp transmit-mgmt
Use the lldp transmit-mgmt command in Interface Configuration mode to include transmission of
the local system management address information in the LLDPDUs. To cancel inclusion of the
management information, use the no form of this command.
Syntax
lldp transmit-mgmt
no lldp transmit-mgmt
Default Configuration
By default, management address information is not included.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to include management information in the LLDPDU.
console(config-if-1/g3)#lldp transmit-mgmt