Dell PowerEdge M805 - Manual (Page 689)

OSPF Commands 695
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
The value for the length of time must be the same for all routers attached to a network.
Example
The following example sets the OSPF hello interval at 30 seconds.
console(config-if-vlan15)#ip ospf hello-interval 30
ip ospf mtu-ignore
Use the ip ospf mtu-ignore command in Interface Configuration mode to disable OSPF maximum
transmission unit (MTU) mismatch detection. OSPF Database Description packets specify the
size of the largest IP packet that can be sent without fragmentation on the interface. When a
router receives a Database Description packet, it examines the MTU advertised by the neighbor. By
default, if the MTU is larger than the router can accept, the Database Description packet is
rejected and the OSPF adjacency is not established. Use the no form of the command to enable
OSPF maximum transmission unit (MTU) mismatch detection.
Syntax
ip ospf mtu-ignore
no ip ospf mtu-ignore
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example disables OSPF MTU mismatch detection on VLAN interface 15.
console(config-if-vlan15)#ip ospf mtu-ignore