Dell PowerEdge M805 - Manual (Page 676)

682 OSPF Commands
www
.dell.com | support.dell.com
Default Configuration
Disabled is the default configuration.
Command Mode
Router OSPF Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example prevents the Summary LSA from being advertised into the area 3
NSSA.
console(config-router)#area 3 stub no-summary
area virtual-link
Use the area virtual-link command in Router OSPF Configuration mode to create the OSPF
virtual interface for the specified area-id and neighbor router. To remove the link, use the no form
of the command.
Syntax
area area-id virtual-link neighbor-id
no area area-id virtual-link neighbor-id
• area-id—Identifies the OSPF area to configure. (Range: IP address or decimal from 0-
4294967295)
• neighbor-id—Valid IP address.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example creates an OSPF virtual interface for area 10 and neighbor router.
console(config-router)#area 10 virtual-link 192.168.2.2