Dell PowerEdge M805 - Manual (Page 643)

IPv6 Routing Commands 647
• protocol—Specifies the protocol that installed the routes. Is one of the following
keywords: connected, ospf, static.
• ipv6-prefix/ipv6 prefix-length—Specifies a IPv6 network for which the matching route
would be displayed.
• interface—Valid IPv6 interface. Specifies that the routes with next-hops on the selected
interface be displayed.
• all—Specifies that all routes including best and non-best routes are displayed. Otherwise,
only the best routes are displayed. If the connected keyword is selected for protocol, the
all option is not available because there are no best or non-best connected routes.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the IPv6 routing table.
console(config)#show ipv6 route
IPv6 Routing Table - 0 entries
Codes: C - connected, S - static
O - OSPF Intra, OI - OSPF Inter, OE1 - OSPF Ext 1, OE2 - OSPF Ext 2
ON1 - OSPF NSSA Ext Type 1, ON2 - OSPF NSSA Ext Type 2
show ipv6 route preferences
Use the show ipv6 route preferences command in Privileged EXEC mode to show the preference
value associated with the type of route. Lower numbers have a greater preference.
Syntax
show ipv6 route preferences
Default Configuration
This command has no default configuration.