Dell PowerEdge M805 User Manual
Page 448
440
SNMP Commands
www
.dell.com | support.dell.com
Syntax
snmp-server v3-host {ip-address | hostname} username {traps | informs} [noauth | auth |
priv] [timeout seconds] [retries retries] [udpport port] [filter filtername]
no snmp-server host ip-address
•
ip-address—Specifies the IP address of the host (targeted recipient).
•
hostname—Specifies the name of the host. (Range:1-158 characters.)
•
username—Specifies user name to use to generate the notification. (Range:1-25
characters.)
•
traps—Indicates that SNMP traps are sent to this host.
•
informs—Indicates that SNMPv2 informs are sent to this host.
•
noauth—Specifies sending of a packet without authentication.
•
auth—Specifies authentication of a packet without encrypting it
•
priv—Specifies authentication and encryption of a packet.
•
seconds—Number of seconds to wait for an acknowledgment before resending informs.
This is not allowed for hosts configured to send traps. The default is 15 seconds.
(Range:1-300 seconds.)
•
retries—Maximum number of times to resend an inform request. This is not allowed for
hosts configured to send traps. The default is 3 attempts. (Range:1-255 retries.)
•
port—UDP port of the host to use. The default is 162. (Range:1-65535.)
•
filtername—A string that is the name of the filter that define the filter for this host. If
unspecified, does not filter anything. (Range:1-30 characters.)
Default Configuration
Default configuration is 3 retries and 15 seconds timeout.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example identifies an SNMPv3 host.
console(config)# snmp-server v3-host 192.168.0.20